topic Error while attaching debugger in Application Development and Automation Discussions

Error while attaching debugger

Stefan-Schnell — Thu, 12 May 2016 14:50:00 GMT

Hello community,

from time to time I get the following error:

I see the post with the same content without an answer here. I see also the post with a solution here, but to delete the project is not really an option, because sometimes it doesn't work and I get the following error after creating a new project:

To reduce this error I check to log on the backend via connection type Custom Application Server, and not Group Selection, but without any difference.

Is there any way to analyze and to isolate the problem?

Thanks for tips and hints.

Cheers

Stefan

Re: Error while attaching debugger

christoph_stoeck — Fri, 13 May 2016 07:05:13 GMT

Hello Stefan,

if you experience this issue from time to time only, it can have something to do with the limited resource of “debugging work processes”.

Please check the value of profile parameter “rdisp/wpdbug_max_no“ on the relevant application server (TA RZ11). It should be set to half the number of dialog work processes (i.e.: rdisp/wp_no_dia / 2).

If everything is OK with the profile parameter and you still experience the issue, please check the number of work processes busy with debugging in TA SM50, once you experience the issue. If you see approx. half the number of dialog work processes busy with debugging at that time, you should be thinking of increasing the number of work processes for the relevant application server or at least increase the value of profile parameter “rdisp/wpdbug_max_no“ a bit.

Hope this helps.

Regards, Christoph

Re: Error while attaching debugger

Stefan-Schnell — Fri, 13 May 2016 09:17:38 GMT

Hello Christoph,

thank you very much for your reply.

That is a very good hint, because our rdisp/wpdbug_max_no is to small.

But if I exceed the number of maximal work processes in debug mode, I get the following message:

Now I will monitor the SM50 to find out if there is a relation between the open dialog processes in debugging mode and the error message. I will report later.

Thanks again.

Cheers

Stefan

Re: Error while attaching debugger

Armin_Beil — Tue, 17 May 2016 09:23:50 GMT

Hello Stefan,

you can have up to 4 active debug sessions per project in parallel. If you get the above message try to open the debug view (e.g. via switch to debug perspective) and check if there are still old debug sessions remaining. You can close them via the terminate button from the toolbar.

Depending on your NetWeaver release it may happen that old debug sessions remain if you close the tabs with embedded GUIs without explicitly terminating the debugged process or the debugger before closing the tab.

Best regards,

Armin

Re: Error while attaching debugger

Stefan-Schnell — Wed, 18 May 2016 11:54:33 GMT

Hello Armin,

thanks for the hint, I will watching at it.

Cheers

Stefan

Re: Error while attaching debugger

Stefan-Schnell — Mon, 06 Jun 2016 10:35:35 GMT

Hello Christoph,

the error has not more occurred again, I think the changing of the parameter configuration solves the problem.

Thanks for the hint.

Cheers

Stefan