topic Re: BAdi in Application Development and Automation Discussions

BAdi

Former Member — Fri, 16 Jun 2006 19:51:35 GMT

Hi,

i need to pass tables, variables etc. in a BAdi from one method to another. is it a good idea to declare those in public section. i did so and it worked fine. however, when i execute the BAdi it says sytax error though it didnt say anything while syntax check and activation...but it worked fine for my funtionality.

any suggestions.

Thanks,

venu.

Re: BAdi

Former Member — Fri, 16 Jun 2006 20:37:00 GMT

Am not sure if your question is declaring the variables and/or passing those to methods (which methods??). Also what do you mean by executing BADI, BADI's are basically enhancements provided by SAP and are executed during some standard transaction(s). Someone can help you if you post more about your problem, which BADI you are trying to enhance and also if you can post the code that would be helpful.

hith

Sunil Achyut

Re: BAdi

Former Member — Fri, 16 Jun 2006 20:53:37 GMT

Hi,

my question was about declarations in the public section of a badi. i'm trying to figure out whether is it a deviation of standards to declare in that way or is it ok.

Thanks,

venu

Re: BAdi

Former Member — Fri, 16 Jun 2006 23:20:40 GMT

When you implement a BADI, you are basically creating a class that implements the interface and this is a normal class. Your declarations in public section will in no way deviate from standards, atleast I dont think you are deviating.

hith

Sunil Achyut

Re: BAdi

dani_mn — Sat, 17 Jun 2006 04:44:27 GMT

Open the interface of the badi and go to methods tab there is a button 'Parameters' declare your variable there to use in methods.

Regards,

Wasim Ahmed

Re: BAdi

Former Member — Sat, 17 Jun 2006 05:33:46 GMT

do the F2 and F3 in the initial Screen of the BADI not in the Method Screen.

regards

Prabhu