topic Debugging Condition Type formula created in VOFM in Application Development and Automation Discussions

Debugging Condition Type formula created in VOFM

Former Member — Fri, 08 May 2015 04:37:17 GMT

Hi,

I have created a condition type formula in VOFM for updating the condition type value. I want to know how can i can debug this routine. I even tried update debgging but still its not working.

Please advice.

Re: Debugging Condition Type formula created in VOFM

guilherme_frisoni — Fri, 08 May 2015 11:51:36 GMT

Hi Kinshuk,

it should be equal to any other program. Set a break-point in source code and recalculate pricing.

IF you cannot set break-point, you haven't run RV80HGEN program to reindex all formulas.

IF you set break-point but it didn't stop, your formula is not correctly set in pricing.

Regards,

Frisoni

Re: Debugging Condition Type formula created in VOFM

kiran_k8 — Fri, 08 May 2015 12:35:14 GMT

Kinshuk,

1.FM Pricing.

2.Subroutine perform xkomv_aufbauen_aus_komt1.

3.Check for the below code

* L O O P Pricing Procedure
loop at komt1 from komk-ix_komt1_v to komk-ix_komt1_b.

4.Within this loop you will find a subroutine

perform (bedingung_pruefen) in program saplv61a if found.

Put a break point on this LOOP and check what is happening at the desired condition type while it is running through all the condition types of that Pricing Procedure ?

K.Kiran.