topic Re: Custom code Usage Analysis in Application Development and Automation Discussions

Custom code Usage Analysis

Former Member — Wed, 25 Feb 2015 04:04:36 GMT

I want to get the data from SAP system for all custom develoed programs execution date and its frequency.
Please let is know the table & method from where I will get the program name and used data.

If any program is available , please share those

If any background job need to be run please let us know...

Regards

Vimal

Re: Custom code Usage Analysis

nikolayevstigneev — Wed, 25 Feb 2015 06:15:16 GMT

Hi, Vimal!

There was a post about UPL recently, you may have a look at it. But it has requirements to solution manager packages.

Re: Custom code Usage Analysis

Former Member — Wed, 25 Feb 2015 06:50:42 GMT

Hi Nikolay

I have gone through the UPL but it needs solution manager. I want to develop my own code which will be a part of some tools.

Can you please let us know that how to extract the data and from which table it is to be extracted ?

The report should be in our format.

Regards

Vimal

Re: Custom code Usage Analysis

RaymondGiuseppi — Wed, 25 Feb 2015 07:03:25 GMT

Question: What is your version, I ask cause you seem unwilling to use Solution Manager and UPL?

You could create a background job to periodically analyze statistical data on your system before they are cleared by a periodically standard job.

Look at following FM

TH_SERVER_LIST - get list of AS (as following FM must be executed on each one)
SAPWL_STATREC_READ_FILE (*) - to read statistic file that are stored in FS of the AS, check returned table parameter V2_NORMAL_RECORDS)

Else you could start searching information on table MONI and similar tables where SAP store some information. (start anamyze transacion ST03N)

Regards,

Raymond

PS: I called this FM on 4.6C but no longer, maybe look at SAPWL_STATREC_DIRECT_READ which replaced this one?

Re: Custom code Usage Analysis

Former Member — Fri, 27 Feb 2015 04:06:55 GMT

HI Raymond

Thanks for reply.

I want to understand that for above below activities to be done.

1. Any RFC need to be created

2. Audit need to be enabled or not... what are the parameters to be activated

Regards

Vimal

Re: Custom code Usage Analysis

matt — Fri, 27 Feb 2015 06:39:27 GMT

You cannot get complete information without UPL and SOLMAN. ST03N (Stats) will give you some information. However you must recognised that it isn't complete. For example, print programs will not be picked up. It also does not tell you about function modules or classes that are in your system and not used. Further the data is not held forever. If the retention time is 3 months, then you have no data older than 3 months.

This question has been discussed many times before; as such I am locking this thread.