topic Re: Module pool validation and display mode in Application Development and Automation Discussions

Module pool validation and display mode

former_member219850 — Tue, 06 Jan 2015 09:03:55 GMT

Hi,

I have attached a screen shot, in which one input field is used to type email address of receiver.

when I enter incorrect email address validation error comes.

But I am unable to re-enter the address again in the field it goes in display mode.

what should I do??

thanks

darshan

Message was edited by: Matthew Billingham - meaningful title

Re: Module pool validation and display mode

former_member219850 — Tue, 06 Jan 2015 09:04:49 GMT

Re: Module pool validation and display mode

ipravir — Tue, 06 Jan 2015 09:08:45 GMT

Hi Darshan,

Put your e-mail validation code in PAI and Use below code, before user_command module.

CHAIN.

field e_MAIL MODULE mod_email_validatie.

ENDCHAIN.

Or.

2 FIELD e_mail MODULE mod_email_validate.

To keep your fields open for input after display an error, always use CHAIN..ENDCHAIN if multiple fields validation and for single Field , write a module based on the FIELD name.

Regards.

Praveer.

Re: Module pool validation and display mode

Former Member — Tue, 06 Jan 2015 09:09:57 GMT

hii Darshan

in your validation condition write else statement and call screen again in that else.

hope it will solve your problem

Regards

Gaurav

Re: Module pool validation and display mode

former_member219850 — Tue, 06 Jan 2015 09:13:08 GMT

thanks a lot..

Re: Module pool validation and display mode

former_member219850 — Tue, 06 Jan 2015 09:29:54 GMT

This message was moderated.