topic Calling 2 subscreens simultaneously in Application Development and Automation Discussions

Calling 2 subscreens simultaneously

manish_malakar0316 — Mon, 01 Dec 2014 11:30:53 GMT

Hi all,

I have a requirement wherein I have to call a subscreen in a screen where a subscreen is already there. But I am unable to figure out where to call it. The select-options and the table control is called via 2 sunscreens. After the user presses 'SUBMIT', the table control should appear below the select-options. Below are the screen shots:

The layout for the select-options and the table control is shown below:

The flow logic for screen 9000 is:

I have called both the subscreens in here.

Now in my output, the table control is appearing along with the select-options which is not correct. It should appear after the user presses 'SUBMIT'.

So where and how do I call the subscreen for the table control so that it appears after PAI?

Regards.

Manish

Re: Calling 2 subscreens simultaneously

Former Member — Tue, 02 Dec 2014 02:57:43 GMT

Hi Manish,

Why not you put output subscreen to another screen. Then call this screen in 'USER_COMMAND'.

You want selection fields and output in same screen, only this output should appeared after you click submit?

regards,

Archer

Re: Calling 2 subscreens simultaneously

Former Member — Tue, 02 Dec 2014 03:22:48 GMT

If yes, then you need another dummy subscreen.

DATA: dynpro01 TYPE c LENGTH 4 VALUE '9003'.

SELECTION-SCREEN BEGIN OF SCREEN 9003 AS SUBSCREEN.

* Nothing in this dummy subscreen.

SELECTION-SCREEN END OF SCREEN 9003.

PROCESS BEFORE OUTPUT.

MODULE STATUS_9000.

CALL SUBSCREEN REF1 INCLUDING sy-repid '9001'.

CALL SUBSCREEN REF2 INCLUDING sy-repid dynpro01.

MODULE user_command_9000 INPUT.

ok_code = sy-ucomm.

CASE ok_code.

WHEN 'SUBMIT'.

dynpro01 = '9002'.

ENDCASE.

ENDMODULE.

regards,

Archer