topic Re: Stop Change Pointer Trigger via Z Program in Application Development and Automation Discussions

Stop Change Pointer Trigger via Z Program

Former Member — Thu, 14 Aug 2014 06:24:53 GMT

Hi,

I have a scenario where I need to deactivate the change pointers via Z program.

For eg. The change pointers need to be created if I triggered a deletion of records via other means. But the change pointers should not be triggered if I deletes the record via one Z program.

How can I achieve this?

Thanks & Regards,

Arun.

Re: Stop Change Pointer Trigger via Z Program

former_member201275 — Thu, 14 Aug 2014 07:35:32 GMT

Change Pointers for which module, HR or...?

Re: Stop Change Pointer Trigger via Z Program

Former Member — Thu, 14 Aug 2014 08:27:16 GMT

Yes HR Module

Re: Stop Change Pointer Trigger via Z Program

former_member201275 — Thu, 14 Aug 2014 09:01:10 GMT

Have a look at BADI BDCP_BEFORE_WRITE. Essentially table BDCP is where these are written to so maybe you can stop this with this BADI i.e. before writing to the table.

This link below contains much useful advice on managing change pointers, and also the standard program for clenaing this up. Perhaps here you can find your answer: http://www.dataxstream.com/2009/07/are-you-properly-managing-your-change-pointers-part-2-a-simple-source-of-runaway-growth/

Re: Stop Change Pointer Trigger via Z Program

former_member201275 — Wed, 20 Aug 2014 11:21:43 GMT

This message was moderated.