Clear parameter after execution

Former Member — Thu, 14 Aug 2014 02:43:38 GMT

Hi Experts,

How can I clear my selection screen after execution(f8)?

I cannot put my clear code at AT-SELECTION-OUTPUT because when I press enter it also clear my parameters.

My requirement is to clear my screen after ececution(f8).

I've tried to put my clear code at START-OF-SELECTION Clear: p_tire, p_sup, p_head. and nothing happens.

Thank you.

Re: Clear parameter after execution

Former Member — Thu, 14 Aug 2014 03:19:37 GMT

Hi Jepoy,

You can refer the below piece of code for your requirement: You can set the flag at Start of Selection.

Then Import the same in the AT SELECTION SCREEN Output event. Make sure to free the memory ID after the Import. This will not clear the Parameter when you press enter.

AT SELECTION-SCREEN OUTPUT.

IMPORT lv_flg FROM MEMORY ID 'CLEAR'.

FREE MEMORY ID 'CLEAR'.

IF sy-subrc eq 0.

CLEAR p_matnr.

ENDIF.

START-OF-SELECTION.

lv_matnr = p_matnr.

EXPORT lv_flg = 'X' to MEMORY ID 'CLEAR'.

Hope this works.

Thanks,

Abhi

topic Re: Clear parameter after execution in Application Development and Automation Discussions

Clear parameter after execution

Re: Clear parameter after execution