topic Re: Help needed on SET/GET parameters in Application Development and Automation Discussions

Help needed on SET/GET parameters

Former Member — Wed, 23 Jul 2014 06:13:00 GMT

Hello All,

I have come accross a wierd issue in one of my development. .I am actually populating some variables using SET / GET parameters to reuse it at another place.

If i check it with my Id, sometimes the variables are filled and sometimes not filled. I am also clearing it at the correct place using FREE statement.

In case if I check with other Ids also same problem exists ( Variables are filled ), thereby some custom changes are refelected only sometimes as these changes are dependent on those variables. To say the process is not consistent.

Will the SET / GET parameter ID work on a particular Id ?

Has anyone come across this kind of issue ( memory clearance problem ) at any point of time ?

I Would like to get this issue fixed ASAP.

Can anyone help in fixing the above issue.

Thanks and Regards,

Karthik Ganti.

Re: Help needed on SET/GET parameters

former_member346628 — Wed, 23 Jul 2014 06:49:29 GMT

Hi Karthik,

Please refer to below link. This might help you.

http://scn.sap.com/thread/746893

Try to store data in INDX table and get form the same again.

Thanks,

Sridhar.S

Re: Help needed on SET/GET parameters

praveenboss — Wed, 23 Jul 2014 07:34:48 GMT

Hi Kartik,

Please show me your code of both SET and GET Parameter Statement.

Thanks.

Re: Help needed on SET/GET parameters

Former Member — Wed, 23 Jul 2014 07:35:33 GMT

Hi Karthik,

The SAP Memory is a user-specific memory area of the current application server, which is accessed by all main sessions of a user session at once.

It has has consequences for programs that one and the same user can run in parallel sessions:

Its depend on the rolled in and rolled out of programs.

It is clearly mentioned in help.sap

SAP MEMORY

I guessing this could be situation,

You opened one session (Old value of parameter loaded initially ) and in another session program which setting the parameter ( New value) . If the session which setting the new value for parameter finished first than other, than when other session completed will over write the value with initial value

Thanks & Regards,

Arun

Re: Help needed on SET/GET parameters

Former Member — Wed, 23 Jul 2014 07:38:21 GMT

Hi karthik,

Try to use submit statement instead of set/get parameter.

Regards Ashwin.kv

Re: Help needed on SET/GET parameters

Former Member — Thu, 24 Jul 2014 05:32:55 GMT

Hi All,

Thank you for your quick responses. I have debugged and seen that I have passed same Parameter ID at some places which is actually overwriting that value. Due to that I was facing issue.

I learned some new points above SET / GET parameters from the above posts which is useful. Thanks once again...!!!!

Thanks and Regards,

Karthik Ganti.