topic Re: Problem with FM - MD_CONVERT_MATERIAL_UNIT (calling from program) in Application Development and Automation Discussions

Problem with FM - MD_CONVERT_MATERIAL_UNIT (calling from program)

former_member203070 — Thu, 22 May 2014 09:41:01 GMT

Hi experts:

I have a problem using the FM - MD_CONVERT_MATERIAL_UNIT.

When I use the FM in dry run (from SE37) its giving me the correct result.

But whenever I'm calling the same FM from my code, its returning SY-SUBRC = 1 .

Please reply.

------------------------------------------------------

data:fp_menge type menge_d.

CALL FUNCTION 'MD_CONVERT_MATERIAL_UNIT'

EXPORTING

i_matnr = '000000000000005382'

i_in_me = 'E21'

i_out_me = 'E24'

i_menge = 4

IMPORTING

e_menge = fp_menge

EXCEPTIONS

error_in_application = 1

error = 2

OTHERS = 3.

write:/ sy-subrc, fp_menge.

Re: Problem with FM - MD_CONVERT_MATERIAL_UNIT (calling from program)

former_member187748 — Thu, 22 May 2014 09:47:03 GMT

Hi Partha,

clearly its an application error, please show the declaration of fp_menge in your program. Please write it as shown below and see is it working or not

DATA : fp_menge TYPE ekpo-menge.

Re: Problem with FM - MD_CONVERT_MATERIAL_UNIT (calling from program)

RaymondGiuseppi — Thu, 22 May 2014 09:53:35 GMT

Did you check for internal/external format of fields and/or conversion-exit, as on units of measure fields (*)

Regards,

Raymond

(*) conversion CUNI based on table T006A language dependant.

Re: Problem with FM - MD_CONVERT_MATERIAL_UNIT (calling from program)

Former Member — Thu, 22 May 2014 09:55:24 GMT

Please pass correct 'Base Unit of Measure'(MARA-MEINS)

Both 4 parameters are pass by value

MARA-MATNR

MARA-MEINS

EKPO-MENGE

All the values should be the above type.

Regards,

Vadamalai.