topic Output type triggering in Application Development and Automation Discussions

Output type triggering

Former Member — Fri, 08 Nov 2013 17:39:36 GMT

For a sales order there is an output type and a routine assigned to that.

after checking couple of checks routine sets sy-subrc = 4 . then the output type should not trigger.

But in the sales order output type is triggering and shows as Red and if I see the determination analysis it says ( output ignored ( routine not fulfilled)

Please let me know if any idea on this.

Re: Output type triggering

Former Member — Fri, 08 Nov 2013 18:51:19 GMT

Hi,

Can you verify the output type configuration with your function consultant

can you copy the driver program form routine.

Thanks,

Kiran

Re: Output type triggering

Former Member — Fri, 08 Nov 2013 21:24:09 GMT

Go to V/32 and check the procedure V10000. You should see the output type used (usually BA00 if standard else ZA00 or something similar). There in the Requirement Field you would see a number.

Go to VOFM, Requirements -> Output control and choose 902. At the top there is a notepad button which when clicked will give you the source code. Check the code in the routine and see if it is actually doing what you want.

Thanks

Re: Output type triggering

nabheetscn — Sat, 09 Nov 2013 04:03:50 GMT

Basically if sy-subrc is set to 4 output wont trigger which is happening.. what exactly is the isaue you are looking for