topic Re: Debug Class in Application Development and Automation Discussions

Debug Class

Former Member — Fri, 19 May 2006 00:48:12 GMT

Dear Gurus,

I am debugging a class and its method.

After break point is set in code, must I set break point from menu again when the debug screen has appeared?

I used the pull-down menu and set the breakpoint as well and it prompts me to enter the class and method. But i not sure to choose global class or local class. Its a z-copy of SAP class.

Also, after sm50, and choosing debug program, nothing happens. What should happen? The initial debug screen with code that system brings me into , i could not see my code.

Pls advise.

Thanks,

Suzie

Re: Debug Class

Former Member — Wed, 31 May 2006 21:56:28 GMT

Once you set the break point and enter debug the program should stop at your break point. If you are trying to debug from BSP/Web Based application, you should set HTTP break point. To set HTTP break point, follow menupath utilities->settings->ABAP editor tab->Debugging tab and then check Actv check box. If you are using command line debugging from ABAP command prompt using /h, then once the debug screen appears hit F8, it will stop at your breakpoint. Thanks.