topic Re: Printing issue in Smartforms in Application Development and Automation Discussions

Printing issue in Smartforms

Former Member — Fri, 31 May 2013 12:42:16 GMT

Dear Experts,

I have a issue in smartform printing.

Whenever I take a printout from Laser Printer the font of the printout appears to be perfectly fine but whenever I take a printout from Dot Matrix Printer then the font appears to be smokey as if the print is in 3D format.

Secondly, I am printing a GR form through Dot Matrix Printer and the page format in the smartform is of

25 CM width &

15 CM Height..

i.e. on A4 size of paper 2 GR's forms will get printed and it gets printed on Pre-printed paper..

But the issue is whenever 2 GR's are printed, first GR gets printed on the 1st pre-printed form and the second GR gets printed on the 3rd Pre-Printed form.

second forms is left blank while printing the 2 GR's..

Regards,

Mahesh

Re: Printing issue in Smartforms

Former Member — Fri, 31 May 2013 14:05:21 GMT

HI its dependent on printer.

Configure your default printer as dot-matrix using Transaction SPAD.

And arrange font as par dot matrix .

Re: Printing issue in Smartforms

Former Member — Fri, 31 May 2013 16:24:12 GMT

This message was moderated.

Re: Printing issue in Smartforms

venkateswaran_k — Fri, 31 May 2013 21:29:14 GMT

You need to confirm the Page Size specified in the smartform is matches with the Printer configuration using SPAD.

Regards,

Venkat

Re: Printing issue in Smartforms

TSG — Sat, 01 Jun 2013 12:15:35 GMT

Hi,

please try to used standard printer device type instead of configure new device type

SPAD.

Ex: your printer is Epson then used Epson_x device type and page format compatible for that printer.