topic Partner XXX does not exist for partner function LS; in Application Development and Automation Discussions

Partner XXX does not exist for partner function LS;

Former Member — Wed, 24 Apr 2013 14:30:04 GMT

Hi all,

I'm trying to configurate an outbound idoc for scheduling agreement (me38).

I make the follows steps:

1- NACO

- Create an access sequence

- Configurate an output type

- Add some condition records

2- WE20

- Select partner type LS

- Create an ORDERS outbound parmtrs

- Partn.Type = LS

- Partner Role = LS

- Message Type = ORDERS

- Basic type = ORDERS05

Message Control

- Application = EF

- Message type = MyMessageType

- Process Code = ME10

But when i go to me38 and trying to create the message, i receive the warning: Partner xxxx does not exist for partner function LS

What i miss on my configuration?

Thank all advance.

Re: Partner XXX does not exist for partner function LS;

Former Member — Thu, 25 Apr 2013 10:11:24 GMT

Hi Eric,

Remove the partner role as LS from the partner profile and try executing the report. Also you may need to create the distribution model in BD64 with sender system as your SAP system and the logical system as destination system.

Cheers

~Niranjan

Re: Partner XXX does not exist for partner function LS;

JL23 — Thu, 25 Apr 2013 10:19:16 GMT

I think this blog can you give a lot insight into the steps needed to EDI messages:

http://scn.sap.com/community/pi-and-soa-middleware/blog/2009/11/10/configure-edi-message-control-base-on-purchase-order-case

Re: Partner XXX does not exist for partner function LS;

Former Member — Fri, 26 Apr 2013 09:16:19 GMT

Hi Eric,

2- WE20

- Select partner type LS

- Create an ORDERS outbound parmtrs // ----Have you provide PORT ?

- Partn.Type = LS

- Partner Role = LS

- Message Type = ORDERS

- Basic type = ORDERS05

Message Control

- Application = EF

- Message type = MyMessageType

- Process Code = ME10

have you created below steps:

1. Create an ORDERS outbound parmtrs // ----Have you provide PORT ?

2. create distribution model by using t.c BD64.

Thanks,

Re: Partner XXX does not exist for partner function LS;

Former Member — Mon, 29 Apr 2013 17:41:17 GMT

Guys,

Thank for all the replies, the problem was solved, had two problems, the first one is that for schedule agreement documents the application that is configurated on NACO is not EF is EL and when you modify on schedule agreement the document needs to be released (approved), it's like purchase order. So after i did this steps the warning message continues to show up but the idoc is generated without mistakes.

Thank you all!!!