topic Re: Problem with configure Message Control in Application Development and Automation Discussions

Problem with configure Message Control

Former Member — Tue, 23 Apr 2013 07:04:41 GMT

Hello everyone,

Can you please help me with such issue. I want to configure through message control creation of Idoc through EDI. It means that after Creation or Changing PO (me21n, me22n) I suppose to get at output Idoc. I did configuration such as creating Partners Profiles, Ports RFC etc , for example as it showed in this topic

but still no matter do I save a new PO or change existing one I still have my messages in status yellow means message not processed.

Can you please kindly help me what is my mistake or what I do wrong .

Re: Problem with configure Message Control

JL23 — Tue, 23 Apr 2013 11:04:42 GMT

What timing did you enter in the message condition?

4 = immediate processing when saving the PO.

otherwise you have to execute message processing in ME9F or with a background job.

Re: Problem with configure Message Control

Former Member — Tue, 23 Apr 2013 11:17:22 GMT

Yes, I entered 4 immediate processing

Re: Problem with configure Message Control

Former Member — Tue, 23 Apr 2013 11:25:14 GMT

And with ME9F I don't see message output for me PO

Re: Problem with configure Message Control

JL23 — Tue, 23 Apr 2013 13:05:33 GMT

are you sure that the PO is not under a release strategy.

It is normal that a message is created, but it gets only process after the PO gets released.

It is not foreseen to output or send a message when the PO is not approved.

Please check in the PO header if you have a release tab and if the PO has its final approval

Re: Problem with configure Message Control

Former Member — Tue, 23 Apr 2013 13:32:05 GMT

Yes you are correct in it! I'm not functional consultant so not even knew about me29n.

Thank you very much!!!!! After I released it Idoc was created!!