topic Re: While doing SPAU,if both programs are identical in Application Development and Automation Discussions

While doing SPAU,if both programs are identical

jaheer_hussain — Mon, 08 Apr 2013 09:44:49 GMT

Hi,

While doing SPAU (by last transport request),I found both programs are identical(left window as well as right window),I can simply skip or I can do re-set.

For this can somebody throw light on this,please?

With Regards,

Jaheer.

Re: While doing SPAU,if both programs are identical

Jelena_Perfiljeva — Mon, 08 Apr 2013 21:31:33 GMT

It's been a while since my last SPAU run, but if both are the same then I'd do "reset to original". Most likely someone was planning to make a change, but then rolled it back. Yet an entry remained that there was a "modification". If you don't reset then most likely it's going to come up again next time.

In general, I tend to use "reset" when in doubt, but we do keep good track of modifications that need to be re-appliead and also do a test run first, so there is little risk of accidentally losing anything.

Re: While doing SPAU,if both programs are identical

Former Member — Tue, 09 Apr 2013 02:17:25 GMT

hello,

Skip won't help. SPAU needs to be all green at the end. So option "reset" is a best bet.

best regards,

swanand

Re: While doing SPAU,if both programs are identical

Former Member — Tue, 09 Apr 2013 03:31:47 GMT

Hi,

Skipping the object from doing the adjustment wouldn't make much difference because there is no difference in the versions you are checking. But, its advised not to keep the object un-attended in SPAU for the reason that system couldn't determine its adjustment during upgrade and pushed it to SPAU so that the developers can take required action.

So, Reset to Original would be the correct choice in your case.

Hope this helps,

~Athreya