topic Re: screen-group1 in Application Development and Automation Discussions

screen-group1

jaheer_hussain — Sat, 15 Dec 2012 09:02:34 GMT

Hello ,

In the below codes.

loop at screen.

if screen-group eq 'A1'

screen-input = 0.

modify screen

endif.

endloop.

Here what is screen-group eq 'A1'? The above code is not working.

Can some throw light on this issue,please?

With Regards,

Jaheer...

Re: screen-group1

Former Member — Sat, 15 Dec 2012 10:36:03 GMT

Hi Jaheer,

Screen groups are field attributes. You can find them in the screen painter.

The error in your code is that there is no group attribute, but group1,group2,group3 and group4.

Be aware that your code must be placed in the PBO of the screen you want to change.

Hope it helps.

Regards,

Christian

Re: screen-group1

jaheer_hussain — Sat, 15 Dec 2012 10:48:00 GMT

Hi Christian,

Below is the my code.

MODULE STATUS_0111 OUTPUT.

IF ( SY-TCODE EQ 'ME23' OR

SY-TCODE EQ 'ME23N' ) .

LOOP AT SCREEN.

IF SCREEN-GROUP1 EQ 'A1'.

SCREEN-INPUT = 0.

MODIFY SCREEN.

ENDIF.

ENDLOOP.

ENDIF.

In the screen attributes I set group1 as 'A'.

But still it is not working. Can you tell please what is the wrong here?

With Regards,

Jaheer

Re: screen-group1

Former Member — Sat, 15 Dec 2012 11:29:07 GMT

You have to set group1 as 'A1' not 'A'.

Re: screen-group1

jaheer_hussain — Sat, 15 Dec 2012 11:32:23 GMT

Sorry I set A1.

With Regards,

Jaheer....

Re: screen-group1

Former Member — Sat, 15 Dec 2012 11:38:49 GMT

still doesn't work?

Re: screen-group1

jaheer_hussain — Sat, 15 Dec 2012 11:42:25 GMT

Yes.Still does not work!!!!!

Re: screen-group1

Former Member — Sat, 15 Dec 2012 11:58:04 GMT

I've tested your code here and it works. I suggest you to move your code to a form routine, set a break point and then see what is happening in the debugger. Perhaps there is a later point that is enabling the field for input again.