topic Reading BSAK dump in Application Development and Automation Discussions

Reading BSAK dump

Former Member — Wed, 06 Jun 2012 11:49:53 GMT

Dear Experts,

The following select gives me a Dump.

I was selecting from bseg before,it gave me a dump.
Then I decided to select the same fields from BSAK.For a while it worked,Now its giving me the dump again.

SELECT bsak~belnr bsak~lifnr bsak~rebzg bsak~zfbdt bsak~zterm bsak~wrbtr bsak~shkzg bsak~buzei
   INTO CORRESPONDING FIELDS OF TABLE gt_spsppo FROM bsak WHERE
                                   bsak~lifnr IN so_kred
                                   AND bsak~bukrs = p_bukrs
                                   AND bsak~augbl NE ''.

How should I modify this call.

Thanks
K

Re: Reading BSAK dump

ThomasZloch — Wed, 06 Jun 2012 12:11:17 GMT

What is the title of the short dump, and please paste the section "error analysis".

Thomas

Re: Reading BSAK dump

Former Member — Wed, 06 Jun 2012 12:19:05 GMT

TSV_TNEW_PAGE_ALLOC_FAILED

Error analysis

The internal table "\PROGRAM= ZUKV_PSP\DATA=GT_SPSPPO" could not be further

extended. To enable

error handling, the table had to be delete before this log was written.

As a result, the table is displayed further down or, if you branch to

the ABAP Debugger, with 0 rows.

At the time of the termination, the following data was determined for

the relevant internal table:

Memory location: "Session memory"

Row width: 242

Number of rows: 15494448

Allocated rows: 15494448

Newly requested rows: 64 (in 1 blocks)

Re: Reading BSAK dump

Former Member — Wed, 06 Jun 2012 12:45:38 GMT

Found the reason.This select was going through an endless loop.