topic Re: Problem on Re-trigger IDOC error status in Application Development and Automation Discussions

Problem on Re-trigger IDOC error status

Former Member — Mon, 14 May 2012 08:33:31 GMT

Hi All,

If i want to re-trigger those error status idoc number, is it possible to set the schedule job to do it ?

If not, is it any function module to re-trigger this?

Regards,

Luke

former_member189779 — Mon, 14 May 2012 08:49:09 GMT

For Outbound:

For 02 status IDocs follow the below procedure:

Program RBDAGAIN. Schedule as job

This would push your Idoc from *02*(Error passing data to port) to 30(Idoc
ready to dispatch) status.

Now to send the Idoc from 30 to *03*(Data passed to port OK) use the
"RSEOUT00" program and run another job as stated above.

This would send the Idocs to 03.

Similarly at Inbound side:

To reprocess an Idoc in 51 status:

Use program "RBDMANI2" and run a job.It will push Idocs from 51 to 53 status.

For 64 status use "RBDAPP01" program.

Former Member — Wed, 23 May 2012 04:24:53 GMT

Thank you very much.