topic Function Group Transport Issue in Application Development and Automation Discussions

Function Group Transport Issue

Former Member — Fri, 06 Apr 2012 22:24:04 GMT

I had an existing function module, I added a perform to it. When asked I put the perform in it's own include. Everything worked fine. Now it was transported to UQ and the include does not show up in the function group. If I go to the function module and doulbe click onit I am told it does not exist. However if I place a break point on the perform line in the function module I can step through the include and all the code.

First I tried transporting just the FM, and new include. I then tried doing the whole function group. The last I tried was the whole package. The include is known to the function module, If I try to create the Include in the function module in UQ it says it already exists. But is is not recognized by the FM by double clicking on it. But is executed by the function module. Any Idea's??

Thanks in advance

Re: Function Group Transport Issue

deepak_dhamat — Sat, 07 Apr 2012 06:01:20 GMT

Hi ,

In se80 give package names and check whether function module and INclude exist in that package .

if not then check in which request it lies

regards

Deepak.

Re: Function Group Transport Issue

former_member215575 — Sat, 07 Apr 2012 09:41:30 GMT

Hi George,

It might be a navigation issue. Some times I too have faced the same.

But I have navigated to the include by temporarily switching to Old Editor(Utilities-->Settings-->ABAP Editor-->Editor Tab--> Front End editor (Old)).

Check if works for you.

Regards,

SG.

Re: Function Group Transport Issue

Former Member — Sun, 08 Apr 2012 07:00:42 GMT

Hi,

Display the function group using tcode SE80 and follow the below navigation and check.

Keep the cursor on the Function group -->Right click and select the 'Other Functions--> Click on 'Rebuild Object List'.

Regards,

Vijaymadhur.

Re: Function Group Transport Issue

Former Member — Sun, 08 Apr 2012 07:09:07 GMT

Hi George,

Have you tried activating the FM in UQ after transporting?

Regards,

Karl

Re: Function Group Transport Issue

Former Member — Mon, 09 Apr 2012 15:09:06 GMT

Thaanks for all the replies, the issue is now resolved. Again much appreciated