topic Re: Wrong Code after executing debugging in Application Development and Automation Discussions

Wrong Code after executing debugging

Former Member — Thu, 05 Apr 2012 15:18:57 GMT

Hello Colleagues,

I have following problem:

If I try to execute debugging of a program under ABAP Editor (SE80), I will see a complete different code in the debugger application.

The Code under ABAP Editor is not the same as at debugger.

Any ideas?

Many thanks in advance!

Regards,

Jochen

Re: Wrong Code after executing debugging

Former Member — Thu, 05 Apr 2012 16:11:31 GMT

Hi,

Just try putting a break point in your code instead of using '/h' and then execute the same. You will then be able to find out if your piece of code is getting triggered or not.

Asha

Re: Wrong Code after executing debugging

Former Member — Fri, 06 Apr 2012 05:08:57 GMT

Make sure your program is activated.

Re: Wrong Code after executing debugging

Former Member — Fri, 06 Apr 2012 06:22:48 GMT

Jochen,

First thing is this SE80 is not your ABAP Editor. It is Obect Navigator.

And just run the tcode and put /h and then execute it.

You can also do through SE38. Just paste the program name and execute it, it will take you to selection screen. Enter details in selection screen and then put /h and again execute it. It will take you to your program.

Re: Wrong Code after executing debugging

yuri_ziryukin — Tue, 10 Apr 2012 11:48:44 GMT

I think this is most probably the case. Only active version of the code is executed.