topic Re: SECATT issue - cannot set parameters in Application Development and Automation Discussions

SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:14:07 GMT

Hi all,

I am having a problem creating a complete test script with SECATT transaction. I can record the transaction, in this case IE01, but then when I transfer the data and try to set the parameters, I get the following message at the bottom of the screen:

Screen Simulator: Wrong screen ID for simulator data. (with no other detail...)

I am following the exact same procedure as I did before (which worked all the way through) but within anoter organization.

Any Idea if there is a way to fix this ?

Thanks for your help.

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:17:46 GMT

What is the message number and ID of the error?

Rob

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:33:57 GMT

Hi Rob,

There is no error message and when double-clicking on the message, nothing else is displayed.

There is just a white check mark in a green circle to the left of the message. I know this usually refers to a warning message but I cannot get anyfurther from that point.

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:45:44 GMT

You could send it to OSS. The worst they will do is tell you that it's a consulting issue.

Rob

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:47:27 GMT

I have no access to OSS but I will find someone to do a search on it and see if there is any fix.

Thanks

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:51:28 GMT

I did and didn't find anything. I meant you should raise an OSS message.

Rob

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:54:20 GMT

The message appeares to be TT 028. Do a where used list on the message. You will find just a few places where it is used. Put a break-point at each and execute the script. If it returns the error, you can see where and why it did so.

Rob

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 19:55:11 GMT

Ok, thanks. But I'd sure like to know if anyone else has experienced this problem and if they were able to fix it somehow.

Re: SECATT issue - cannot set parameters

Former Member — Fri, 03 Feb 2012 20:05:36 GMT

If you'll search the forums and try Google, you'll see that a few others have seen this problem, but no solutions.

Rob

Re: SECATT issue - cannot set parameters

Former Member — Sat, 04 Feb 2012 15:34:47 GMT

I have tried to get the portion of the code associated with this message. Would we be able to have a clear desription (I am not that familiar with ABAP) as to what it refers to ?

DATA: BEGIN OF dname,

prog LIKE scrp_enq-prog,

dnum LIKE scrp_enq-dnum,

END OF dname.

data dref like line of locfields.

IF ( gen_list-gen_mpool <> gen_mpool

OR gen_list-gen_dynnr <> gen_dynnr )

AND

( gen_list-src_mpool <> gen_mpool

OR gen_list-src_dynnr <> gen_dynnr ).

MESSAGE e028 RAISING wrong_dynpro.

ENDIF.

Thanks