topic Re: Syntax with decimals in Application Development and Automation Discussions

Syntax with decimals

Former Member — Thu, 08 Jun 2006 18:13:27 GMT

Hi,

Can any one help on the syntax.

if value format is 1.000 then I should get it as 1 and

if value format is 0.120 then it should remain as 0.120.

I have tried with systax mod but it does not work.

Any help would be appreciated.

Thanks,

Satish

Re: Syntax with decimals

Former Member — Thu, 08 Jun 2006 18:17:49 GMT

hi Mark,

One way of doing that is as below

data var1 type float value '1.000',

var2 type i.

var2 = var1.

write : var1, var2.

else,

<b> if var1 >= 1.

var2 = var1.

var1 = var2.

else.

var1 = var1.

endif.

write : var1, var2.</b>

Regards,

Santosh

Re: Syntax with decimals

Former Member — Thu, 08 Jun 2006 18:41:23 GMT

Try:


REPORT ztest MESSAGE-ID 00.

DATA: p(6) TYPE p DECIMALS 3 VALUE '1.000',
      q(6) TYPE p DECIMALS 3 VALUE '0.120',
      i TYPE i.

MOVE p TO i.

IF i = p.
  WRITE: /001 i.
ELSE.
  WRITE: /001 p.
ENDIF.

MOVE q TO i.

IF i = p.
  WRITE: /001 i.
ELSE.
  WRITE: /001 q.
ENDIF.

Rob

Re: Syntax with decimals

RichHeilman — Thu, 08 Jun 2006 18:43:30 GMT

Here is one way.



report zrich_0001 .

data: var1 type p decimals 3 value '1.123'.
data: var2 type i.
data: fraction type p decimals 3.

fraction = frac( var1 ).

if fraction > 0.
  write:/ var1.
else.
  var2 = var1.
  write:/ var2.
endif.

Regards,

Rich Heilman

Re: Syntax with decimals

Former Member — Thu, 08 Jun 2006 18:43:51 GMT

Hi Mark,

you can use 'frac' statement to check if the decimals part is '0' or not.

*Code starts here

*var1 can have either '0.120' or '1.000' value

data : var1 type p decimals 3,

var2 type p decimals 3,

var3 type i.

var2 = frac( var1 ).

if var2 eq 0. " true for '1.000' value

var3 = var1. "var3 will be '1' now

endif.

*else use var1 only which will be '0.120'

*Code end here

Cheers,

Vikram

Pls reward for helpful replies!!