topic Re: how to put display-only condition in a custom include program in Application Development and Automation Discussions

how to put display-only condition in a custom include program

Former Member — Wed, 26 Apr 2006 20:14:29 GMT

hello everyone,

I have to make a custom include program that will be used instead of the already available 'bdcrecx1'.

I have a couple of questions and would appreciate your help.

I need to create a parameter with a checkbox. When this checkbox is 'X' the following 2 fields need to be greyed out, otherwise user should be able to enter values in them. How can I grey out the fields?

Using my include I should have just the following:

1)parameter with checkbox

(if 'X', session and user greyed out)

2)Session Name

3)User Name

Also, is there a way I can avoid putting the following onto the screen:

1)Keep session (this will always be defaulted to 'X'

2)No Data

<b>Note:</b> I made a copy of 'bdcrecx1'and i'm doing changes according to my requirement.

Thanks in advance.

Regards,

Fred.

Re: how to put display-only condition in a custom include program

Former Member — Wed, 26 Apr 2006 20:34:14 GMT

Hi,

For your first question.

use

assign user command for checkbox say 'CLICK'..

at selection-screen output.

loop at screen.

if screen-group3 = 'VALUE' and checkbox condition.

screen-active = 0.

else

screen-active = 1.

endloop.

To make sure that the user enters the data in fields if checkbox is not grayed,

do it in event

start-of selection.

if field is initial.

exit.

go back to previous screen.

endif.

for removing 'keep session' , check out for exits..

Regards,

Tanveer.

Please mark helpful answers

Sorry about the previous error in reply.

Message was edited by: Tanveer Shaikh

Re: how to put display-only condition in a custom include program

Former Member — Wed, 26 Apr 2006 20:42:56 GMT

parameteR : TEST TYPE CHECKBOX DEFAULT 'X'.

PARAMETER : USER(20),

SESSION(20).

AT SELECTION-SCREEN OUTPUT.

IF TEST = 'X'.

LOOP AT SCREEN.

CASE SCREEN-NAME.

WHEN 'SESSION'.

SCREEN-INPUT = 0.

MODIFY SCREEN.

WHEN 'USER' .

SCREEN-INPUT = 0.

MODIFY SCREEN.

ENDCASE.

ENDLOOP.

ENDIF.

start-of-selection.

end-of-selection.

Re: how to put display-only condition in a custom include program

Former Member — Wed, 26 Apr 2006 21:56:20 GMT

Hi Vick,

If i put the test parameter 'type', it works. But when i put parameter: test as checkbox, the 'session' and 'user' are not greyed out.

And is there a way i can hide: Keep session and No Data.

Thanks.

Regards,

Fred.

Re: how to put display-only condition in a custom include program

Former Member — Wed, 26 Apr 2006 22:36:04 GMT

i made a couple changes and it works now.

Thanks again.

Regards,

Fred.