topic Re: drawing a line(smart forms) in Application Development and Automation Discussions

drawing a line(smart forms)

Former Member — Mon, 22 May 2006 10:02:25 GMT

Hi all,

What is the procedure to draw a horizontal line or empty box.

Thanking you.

Re: drawing a line(smart forms)

Former Member — Mon, 22 May 2006 10:05:22 GMT

YOu can create a new window with the box shading(BOrder) check box checked.

For line, the window height shold be zero.

Regards,

Ravi

Re: drawing a line(smart forms)

Former Member — Mon, 22 May 2006 10:07:51 GMT

Hi Balakrishna,

Hi.

Either you can use a window that takes up the width of your page and only has a hight if 1 mm.

then you put a frame around it (in window output options).

Thus you have drawn a box but it looks like a line.

Or you can just draw "__" accross the page and play with the fonts so that it joins each

UNDER_SCORE.

Award points if helpful.

regards,

keerthi.

Re: drawing a line(smart forms)

rahulkavuri — Mon, 22 May 2006 10:10:03 GMT

check the above thread

Re: drawing a line(smart forms)

Former Member — Mon, 22 May 2006 10:13:20 GMT

GOOD

Setting default parameters for a box:

You can use the POSITION and SIZE commands to set default parmeters for a box.

Instead of:

/: BOX XPOS '11.21' MM YPOS '5.31' MM HEIGHT '10' MM WIDTH '20' MM INTENSITY 10 FRAME 0 TW

You can write:

/: POSITION XORIGIN '11.21' YORIGIN '5.31' MM

/: SIZE HEIGHT '2' MM WIDTH '76' MM

/: BOX FRAME 10 TW INTENSITY 10

This can be usefull if you gave several boxes that share the same parameters.

If you want to set the position realtively to the window use POSITION WINDOW

to set the position to the top/left start of the window. Then use POSITION

to set the current position relatively to the start of the Window.

Note that you uses "+" or "-" in the ORIGIN position to the set the position relatively.

/: POSITION WINDOW

/: POSITION XORIGIN '5' MM YORIGIN '10' MM

the position is now 5 MM from the left and 10 MM from the top of the window

NOTE: After using the position command you can move the current position

realtively to the last used position

/: POSITION XORIGIN '10' MM YORIGIN '20' MM

Now the position will be X = 15 and Y = 30

Drawing a line. You can draw a line by setting the Height or Weidth to 0

and add a frane. E.g. a horizontal line:

/: SIZE HEIGHT '0' MM WIDTH '200' MM

/: BOX FRAME 10 TW XPOS '11.21' MM YPOS '14.81' MM INTENSITY 100

THANKS

MRUTYUN