topic Re: Enhancement point code not triggered in Application Development and Automation Discussions

Enhancement point code not triggered

Former Member — Thu, 12 May 2011 04:05:33 GMT

We are using standard include LMEDRUCKF1O in one of the Custom function module developed in our project.

It contains code for enhancement point implemented by SAP as shown below.

But the enhancement point code is not getting triggered when I execute the Custom function module with relevant data.

Basically the enhancement point code is not loaded wheh I check in debugging...

what could be the reason?...

ENHANCEMENT 28 ISAUTO_SCH_EMM_SAPLMEDRUCK. "active version

if nast-sort1 = 'SWP'.

itcpo-tdgetotf = 'X'.

endif.

ENDENHANCEMENT.

madhu_vadlamani — Thu, 12 May 2011 04:15:12 GMT

Hi Remo,

But the enhancement point code is not getting triggered when I execute the Custom function module with relevant data.

Basically the enhancement point code is not loaded wheh I check in debugging..

Are you able to see the debug point in standard .

Regards,

Madhu.

Edited by: madhurao123 on May 12, 2011 9:45 AM

Former Member — Thu, 12 May 2011 04:30:08 GMT

Hi Madhu,

When I try to set debugging point it is asking to select the main program.

If I select only custom include then I am not able to set break point. Else If I select both custom and standard then I am able to set break point.

madhu_vadlamani — Thu, 12 May 2011 04:35:07 GMT

Hi Remo,

I am able to keep break point in this include MIOLXF14. Can you copy the entire program into zprogram.

Regards,

Madhu.

Former Member — Thu, 12 May 2011 05:55:03 GMT

Hi Madhu,

We created custom function module and calling performs of standard include in that custom function module.

I understood why it was not triggering. Thanks for your help.

Regards,

Remo