topic Re: Custom infotype getting error in overview in Application Development and Automation Discussions

Custom infotype getting error in overview

Former Member — Tue, 11 Jan 2011 18:24:59 GMT

I have a custom infotype that short dumps when I click on the overview button. The message that I get is 'Syntx error or generation error in a screen.' The error analysis says 'Screen "MP900500" 3000 could not be generated.'. Screen 3000 is the screen that is created by SAP when you create the custom infotype. Does anyone know how to correct this?

Re: Custom infotype getting error in overview

Former Member — Tue, 11 Jan 2011 18:37:53 GMT

In the PAI there should be a comment telling you that all fields need to be included in a couple of areas. Add the new fields to these areas of the PAI and it should work.

That's in the single screen - 2000.

Rob

Edited by: Rob Burbank on Jan 11, 2011 1:39 PM

Re: Custom infotype getting error in overview

Former Member — Tue, 11 Jan 2011 19:15:51 GMT

Rob,

I have all of the fields in the structure in both of the chain sections of the PAI. do they have to be in the order that they are in the structure? I also tried removing the display only fields from the section that said 'check and mark if there was any input: all fields that accept input HAVE TO BE listed here'. The screen works normally, it just dumps when I click the overview button.

Thanks,

Paul

Edited by: Paul Sullivan on Jan 11, 2011 8:39 PM

Re: Custom infotype getting error in overview

Former Member — Tue, 11 Jan 2011 20:46:13 GMT

I don't think they have to be in order. I think I had this sort of error when I left out a field though.

It was a while ago, so I may be misinterpreting my thoughts here

Rob