selection screen field

Former Member — Thu, 11 Nov 2010 10:43:17 GMT

Hi,

A field in the selection screen of the report program should be disabled by default.

I have written the logic for the same in at selection-screen output.

If the user enters value in another field in selection screen,the field should be enabled for input.

When the user executes the program,o/p is displayed.

When the user clicks back button in the o/p screen,the field is again shown in disabled mode as the event at selection screen o/p is being triggered.

The field should be enabled when the user cliks back button in the o/p.

How to achieve this? => by writing the code. And we cannot do that for you.

Moderator Message: Also,

Total Questions:  141 (102 unresolved)

suggests that you do not get back to the people who spend time on your issues. Be a responsible forum member by acknowledging people's time and effort.

Edited by: kishan P on Nov 11, 2010 4:16 PM

Re: selection screen field

Former Member — Thu, 11 Nov 2010 10:53:50 GMT

Hi,

If i understood correctly you requirement you just have to make use of a global variable i.e. gv_enabled, which will be used as flag. Before disable the field in at selection-screen output event, check if gv_enabled is initial. When you enable the field for input, for the first time just move 'X' to gv_enabled.

Best Regards

George Zervas

topic Re: selection screen field in Application Development and Automation Discussions

selection screen field

Re: selection screen field