topic Re: Material Master data transfer to external system in Application Development and Automation Discussions

Material Master data transfer to external system

senthilraja_ramasamy2 — Thu, 02 Sep 2010 12:13:26 GMT

Dear All,

We are creating the Interface between SAP and MES system for transfering the material master. The plan is to use the standard Idoc type/message type i.e is MATMAS05.

I have done basic settings like defining parnters, port, partner profile etcc. and trying to trigger the IDoc using transaction code POIM. I am getting a message called " "0 Idocs were generated (According to the selection and filter)". I could not findout why system is throwing this message.

Please help in this issue.

Regards,

Senthilraja

Re: Material Master data transfer to external system

uwe_schieferstein — Thu, 02 Sep 2010 12:54:29 GMT

Hello Senthilraja

I usually use transaction BD10 to send MATMAS IDocs to external system. However, in order to do so you need to define a distribution model ( BD64 ) where you define source system, target system and the message(s).

I assume that transaction POIM requires such a distribution model, too.

Regards

Uwe

Re: Material Master data transfer to external system

senthilraja_ramasamy2 — Thu, 02 Sep 2010 15:24:26 GMT

Thanks Uwe,

I tried to create IDoc with BD10 for material master and I am getting two error msg as below.

Msg one

1 master IDocs set up for message type MATMAS

then Msg two

0 communication IDoc(s) generated for message type MATMAS

Is it able to get why this msg is comng and no IDoc's were generated..

Regards,

Senthil

Re: Material Master data transfer to external system

Former Member — Fri, 03 Sep 2010 04:21:31 GMT

Hi,

The communication IDoc is the actual Idoc which you will see at the end.

i think distribution model/partner profiles is missing. please check

while running BD10 you need to select the receiver LS against which you maintained the partner profiles.

Regds,

Suresh