topic Re: table control (dialog programing) in Application Development and Automation Discussions

table control (dialog programing)

Former Member — Tue, 17 Aug 2010 07:14:48 GMT

Hi All,

I have a tble control, created through Tabl;e Control Wizard, My requirement is to dispaly and edit data in the table control. I have disabled two columns but at run time all the columns sholud me at enabled mode.

How can it is possible?.

Need help.

Thanks in advance.

Re: table control (dialog programing)

Former Member — Tue, 17 Aug 2010 07:20:29 GMT

Hi,

In item of table control, double click on column you want to disable input. In attribute tab, uncheck at Input field.

Please check and reply.

regards,

Re: table control (dialog programing)

Former Member — Tue, 17 Aug 2010 09:18:31 GMT

Hello,

In runtime if you want to enable fields means, in debugging mode you need to open the name of the control and you will find many options.

Change those parameters dynamically. You can enable the disabled columns.

Regards,

Vamsi Krishna

Re: table control (dialog programing)

Former Member — Wed, 18 Aug 2010 05:18:28 GMT

Hello,

data : cols like line of tc2001-cols.

In PBO of screen You can set

cols-screen-input = 1.

depending on the column name.

Regards,

Rachana

Re: table control (dialog programing)

bbalci — Wed, 18 Aug 2010 11:39:32 GMT

Hi Ravi,

In PBO you should see the loop below

if it created by the wizard :

LOOP AT ITAB

WITH CONTROL TBCONT

CURSOR TBCONT-CURRENT_LINE.

MODULE TBCONT_GET_LINES.

*&SPWIZARD: MODULE TBCONT_CHANGE_FIELD_ATTR

ENDLOOP.

Can u see any module except for MODULE TBCONT_GET_LINES in this control loop

or a module after this loop?

It is possible to change editable attribute of table control line by line

even cell by cell. But it could be in PBO.

Re: table control (dialog programing)

Former Member — Wed, 18 Aug 2010 11:46:48 GMT

Hi Ravi,

If you want 2 fields to be disabled for input and rest to be enabled, you need to select input option during the creation of table through wizard and after creation go to that particular cell which needs to be disabled(Not the header, any cell below that) and mark output only as its attributes.

Regards,

Nagraj