topic Re: IDOc Message type MATMAS in Application Development and Automation Discussions

IDOc Message type MATMAS

Former Member — Thu, 01 Jul 2010 17:24:22 GMT

Hi,

when I manual create material master in one plant after that I want to use IDOC Message type "MATMAS" For Distribute material master for create on other plant (2000,3000,...) in same sytem how I can configuration or Enhancement

Regards,

Re: IDOc Message type MATMAS

Former Member — Fri, 02 Jul 2010 05:53:13 GMT

Hi,

Here is a quick guide for you for ALE Settings:

First of all you need two logical systems, one will act as sender and other as reciever .

1)Define logical systems through BD54.

2) Assign clients to logical systems (SCC4)

3) Create RFC Destination (SM59)

4) create port(we21)

5) Create Partner profile

If all these steps are done then go to BD64, there

1) Create Model view

2) Mention your sender and Reciever for that Model (logical systems)

3) Mention The message type

4) Distribute your model view through Environment -> Distribute

If model view is distributed sucessfully that means messages can flow sucessfully between two systems. To ensure your your model view is distributed sucessfully, take special care while setting up partner profiles in sending and recieving system.

Regards

Vinod

Re: IDOc Message type MATMAS

Former Member — Fri, 02 Jul 2010 06:02:16 GMT

Hi,

If you want to extend the materials to other plants in same system, there is no need of using IDOC.

Use the BAPI "BAPI_MATERIAL_SAVEDATA" to extend the material to other plants.

Read BAPI documentation for more details.

Regards

Vinod

Re: IDOc Message type MATMAS

Former Member — Fri, 02 Jul 2010 11:44:36 GMT

Check BD10 .

Re: IDOc Message type MATMAS

Former Member — Fri, 02 Jul 2010 15:06:11 GMT

Thank you for your answer I set all parameter already. Now I can distribute material create only one plant

I will try it again.

regards,

Re: IDOc Message type MATMAS

Former Member — Wed, 28 Jul 2010 06:07:26 GMT

Hi,

You gotto create filters in the distribution model for plants. At the sender, you gotto extend the plants for those particular plants via MM01(when you create material master) or MM02 (change material).

When you now send the materials, they would be replicated for the corresponding plants for which they are configured.

~ Bineah