topic Re: Program is not passed during debugging in Application Development and Automation Discussions

Program is not passed during debugging

Former Member — Thu, 24 Jun 2010 03:09:20 GMT

hi all,

i have a print program for my form in sapscript,

it is triggered by transaction code HUMO, i have placed a breakpoint in my print program

during debugging though, the breakpoint was not passed

am i missing something?

thanks: AUDI

Former Member — Thu, 24 Jun 2010 03:48:24 GMT

Start the program in debugging mode.

Once inside Debugger, you may try to switch on "System Debugging" option in ABAP Debugger.

Press F8. Debugger may stop at your breakpoint.

Former Member — Thu, 24 Jun 2010 05:41:30 GMT

i did that, but still it doesnt pass my print program

Former Member — Thu, 24 Jun 2010 07:41:11 GMT

Hi,

Try using statement,

BREAK-POIINT.

Former Member — Thu, 24 Jun 2010 07:51:02 GMT

i did that aswell no result

Former Member — Thu, 24 Jun 2010 07:54:22 GMT

Hi,

Hope your program is triggered using the output type.

If yes, Put break-point in print program,then before saving the transaction, start debug using /h.

Once the debugger is started, then select the menu option Settings -> Update debugging. System will show the message

"Update debugging switched off" on the status bar. Press F8 to continue the execution.

Control will stop at the place where you created the break point.

Regards

Vinod