topic Target system setup for eCATT - Webdynpro Automation in Application Development and Automation Discussions

Target system setup for eCATT - Webdynpro Automation

CHERIANS — Mon, 21 Jun 2010 07:25:54 GMT

Hi,

I was trying to record on an ABAP WD application. On starting to record after providing Application and Parameters I get an error popup" An error probably occured during logon. I checked the logon details in RFC and did connection test as well. It went fine. I raised a ticket against eCATT component. I was told that the problem was not with eCATT but with the setup of target system. Could some one please help me with target system setup details for eCATT WD automation.

Best Regards

Stephen

Re: Target system setup for eCATT - Webdynpro Automation

markus_dinkel — Mon, 21 Jun 2010 08:03:12 GMT

Hello Stephen,

you have to distinguish mainly two scenarios - with and without https.

1. For Web Dynpro applications without https, e.g. http://my_server.wdf.sap.corp:12345/sap/bc/webdynpro/sap/my_app, you have to use the following data in your HTTP destination:

Target Host: my_server.wdf.sap.corp

Service No: 12345

Logon Procedure: "SAP Standard"

SSL: "Inactive"

In area "Logon": logon data for the target system

2. For Web Dynpro applications with https, two things will be different:

- The Service No will be a different one, e.g. 54321

- You have to set SSL to "Active"

I hope this helps.

Best regards,

Markus

Re: Target system setup for eCATT - Webdynpro Automation

CHERIANS — Mon, 21 Jun 2010 08:49:06 GMT

Hi Markus,

It worked. Thanks for your support.

Best Regards

Stephen