topic Re: How to hard code IF condition in Application Development and Automation Discussions

How to hard code IF condition

Former Member — Fri, 14 May 2010 09:07:55 GMT

Hi frnds,

In below code i want to hard code plant PALM.

IF plant is PALM then only if condition will fire other wise it raise a below mentiond message

I am taking that PALM value from the screen.

PALM Plant Validation

if wa_table-plant_palm is not initial.

select single matnr werks from marc into wa_marc where matnr eq wa_table-material

and werks eq wa_table-plant_palm.

if sy-subrc eq 0.

select single matnr werks from marc into wa_marc where matnr eq wa_table-component

and werks eq wa_table-plant_palm.

if sy-subrc <> 0.

message 'Component does not exit in this plant' type 'E'.

endif.

else.

message 'Material does not exit in this plant' type 'E'.

endif.

Edited by: Rakhi@abap on May 14, 2010 11:08 AM

Re: How to hard code IF condition

Former Member — Fri, 14 May 2010 09:12:27 GMT

hi,

Here my understanding is if plant is PALM then only your if condition sgould work. If its the erquirement, then declare a constant t hold the value PALM, and use it in the same IF condition.

constants: c_palm(4) VALUE 'PALM'.

IF wa_table-plant_palm is not initialAND wa_table-plant_palm EQ c_palm.

your code

ENDIF.

Re: How to hard code IF condition

Former Member — Fri, 14 May 2010 12:25:17 GMT

You can do what harikrishanan said.

Regards

Sagar

Re: How to hard code IF condition

Former Member — Fri, 14 May 2010 14:03:38 GMT

Thanks...