topic Re: display only output mode after saving data in module pool in Application Development and Automation Discussions

display only output mode after saving data in module pool

Former Member — Thu, 16 Mar 2006 08:03:30 GMT

hi..

i am working on a module pool..after input the data and press save button..i want all fields in display mode only..

how should i do this...

please reply..

Re: display only output mode after saving data in module pool

Former Member — Thu, 16 Mar 2006 08:05:00 GMT

use

loop at screen.

if screen-name = ''.

screen-input = '0'.

modify screen.

endif.

endloop.

Re: display only output mode after saving data in module pool

Former Member — Thu, 16 Mar 2006 08:09:20 GMT

Write this code in PBO of the screen

loop at screen.

if screen-name = <fieldname> or

screen-group1 = <group name>.

screen-input = '0'.

modify screen.

endif.

endloop.

Re: display only output mode after saving data in module pool

Former Member — Thu, 16 Mar 2006 08:11:49 GMT

in ur code

proir to this use the screen groups which u 'll find in the field attributes of the fields in the table control.

this will be like screen group1, group 2 group 3 group4 .

now in ur screen

as u say assign all the fields u want to see them in display mode to a screen group.

say screen group1 = 001

in ur PAI code

when 'SAVE'.

loop at screen.

if screen-group1 = 001.

screen active = '0'.

modify screen.

endif.

endloop.

effect is this makes all the screen fields of group 001 into display mode .

hope this helps u ,

regards,

vijay.

typical code will be like this.

u can completely or partially(restrict the fields) using this method.

LOOP AT SCREEN.

IF SCREEN-GROUP4 = 'SC4'.

SCREEN-INPUT = 1.

MODIFY SCREEN.

ENDIF.

ENDLOOP.

Message was edited by: Vikky

Re: display only output mode after saving data in module pool

Former Member — Fri, 05 May 2006 05:29:19 GMT

Hello i want to do this..

user will input the user id in the 1st screen..

then system will display related info abt the student on 2nd screen..how to do that?

data:

stud_id

name

addres

etc

Re: display only output mode after saving data in module pool

abdul_hakim — Fri, 05 May 2006 05:31:32 GMT

hi write the below code

<b>LOOP AT SCREEN.

IF SCREEN-NAME = <UR SCREEN FIELD NAME>.

SCREEN-INPUT = 0.

MODIFY SCREEN.

ENDIF.

ENDLOOP.</b>

Cheers,

Abdul Hakim

Re: display only output mode after saving data in module pool

hymavathi_oruganti — Fri, 05 May 2006 05:36:03 GMT

save all the paramets in one group by specifying modif-id

at the end of each parameter declaration

ex: paramter s type i modif-id afg.

loop at screen.

if screen-group1 = 'afg'.

screen-input = 0.

modify screen.

endif.

endloop.