topic Re: format address in sap script in Application Development and Automation Discussions

format address in sap script

Former Member — Mon, 19 Apr 2010 18:51:51 GMT

Hi,

I have a requirement in which i have to modify address displayed using sap script. The address is displayed using ADDRESS... ENDADDRESS. There is only one street field available. I need to display STREET1, STREET2 and STREET3. In the case of names, there is a provision to display up to four names seperated by commas. Please advise what can be done in this situation.

I had tried to use another field for street but most of the fields are already used.

Thanks a lot in advance.

Re: format address in sap script

DavidLY — Tue, 20 Apr 2010 02:21:29 GMT

Hello,

The standard ADDRESS command really does not

support fields like name_co, street2 and street3. If you

want to print these fields, you can enter the address into

central address management. After that print the address via:

/: ADDRESS

/: ADDRESSNUMBER adress number

/: FROMCOUNTRY sender country

/: ENDADDRESS

where 'address number' is the number of the address. On this

way you will get all fields of the address.

Regards,

David

Re: format address in sap script

Former Member — Tue, 20 Apr 2010 04:09:50 GMT

Good day,

Check this forum it will help you.

Regards and Best wishes.

Re: format address in sap script

Former Member — Tue, 20 Apr 2010 05:18:36 GMT

Hi,

Thanks a lot for your valuable time.

I was not able to do anything. I had to discuss and make the client understand. Hence I had addedd Street1 and Street 2 after the Name1/Name2 in the NAME field and then Street3 under the STREET.

I had to manipulate it. In case, if i could have done in any better way, Please let me know as it would be helpful in future.

Thank you.

Niranchan.

Re: format address in sap script

Former Member — Tue, 20 Apr 2010 08:55:12 GMT

Use FM ADDRESS_INTO_PRINTFORM to get the whole address.

Pass the address number to ADDRESS_NUMBER and ADDRESS_TYPE as 1. You will get all the streets maintained in address from parameter ADDRESS_PRINTFORM_TABLE.

You have to call the FM using PERFORM ENDPERFORM statement in the script.

Re: format address in sap script

Former Member — Tue, 20 Jul 2010 14:23:16 GMT

no comments.

Re: format address in sap script

Former Member — Fri, 19 Dec 2014 05:33:05 GMT

Hi David ,

I have a similar requirement as you are discussing. I am using the same logic what you have said above but the thing is I am not getting the District field (ORT02) by using the standard.

Can you please tell me if I need to do any setting to get the field by passing address number.

You have used the word central address management , can you tell me how do I do that.

Need your support for closing the issue ...

Thanks

Raj