topic Re: Error in a submit program in Application Development and Automation Discussions

Error in a submit program

Former Member — Fri, 12 Feb 2010 11:11:33 GMT

Hello,

In a program, there is a "submit and return" of another program. When they occurs an error in the second program (message error), the traitement stops and don't returns to the first program.

How can it be possible to return to the first program even if there is an error in the second program?

Thanks,

Regards,

Patrice.

Re: Error in a submit program

Subhankar — Fri, 12 Feb 2010 11:16:51 GMT

Hi...

It is not possible to came in the previous program if there is any error message in the submitted program...

One thing you can do. Instead error message when any error occurred exit from the submitted program.

Thanks

Subhankar

Re: Error in a submit program

anup_deshmukh4 — Fri, 12 Feb 2010 11:21:38 GMT

Try using proper message types in just like I E or S A W X etc....the second program...or just ignor the errors in the second program if they are not critical...!

Check for the significance of the message type above ...!

hope it helps...!

Thanks

Edited by: Anup Deshmukh on Feb 12, 2010 12:22 PM

Re: Error in a submit program

kesavadas_thekkillath — Fri, 12 Feb 2010 11:35:29 GMT

instead of raising the error,

try like

if l_v ne 1.

return.

endif. or

if l_v ne 1.

exit.

endif.

Re: Error in a submit program

Former Member — Fri, 12 Feb 2010 11:40:25 GMT

In your second program write Error message as

MESSAGE <message text> TYPE I DISPLAY LIKE E

STOP.

Regards,

Mohaiyuddin

Re: Error in a submit program

Former Member — Fri, 12 Feb 2010 12:22:23 GMT

Hello,

Thanks for your answers. The problem is that I can't modify the submitted program. It's a standard program.

Patrice.

Re: Error in a submit program

vinod_vemuru2 — Fri, 12 Feb 2010 12:29:41 GMT

Hi,

If your program is not dependent on the SUBMITTED program (Some thing like that standard program doesn't have any output) then you can try in below way.

CALL JOB_OPEN

SUBMIT standard program

CALL JOB_CLOSE.

This creates a batch job for standard program.

If your program is dependent, then i don't see any possibility other than doing the same validations in your program before calling the standard program.

Thanks,

Vinod.