topic Re: Terminating debugger session window in Application Development and Automation Discussions

Terminating debugger session window

rainer_hbenthal — Tue, 02 Feb 2010 09:34:43 GMT

Hi,

sometimes the debuger session window is not closed after program end. As far as i remeber there is a command like /h to release the debugger window from the actual session and closes it.

Of course i can switch to that window and close it via x, put sometimes its faster to have a shurtcut.

I tried several / commands, but none of them worked as desired. So can ynoyone tell me the command to do that?

Re: Terminating debugger session window

GauthamV — Tue, 02 Feb 2010 09:38:50 GMT


> sometimes the debuger session window is not closed after program end. .
>

Yes, sometimes you have to come out of the session to end the debugging mode.

Did you try /n or /i ?

Re: Terminating debugger session window

Former Member — Tue, 02 Feb 2010 09:52:30 GMT

Hi,

Yes it will not come out till u completely come out of the particular transaction where u r debugging.

You can try by /n.

Mostly if u donot require at all the ...

Than you can stop the transaction or EXIT.

Regards

Arbind

Re: Terminating debugger session window

rainer_hbenthal — Tue, 02 Feb 2010 09:57:00 GMT

/n just goes to the root without closing the window, /i closes both

Re: Terminating debugger session window

GauthamV — Tue, 02 Feb 2010 10:05:01 GMT

I am working in ECC 6.0 and /i is perfectly working for me.

Not sure about other versions.May be you can try that /hx in other versions.

Re: Terminating debugger session window

rainer_hbenthal — Tue, 02 Feb 2010 10:53:55 GMT

This is my scenario:

i'm in the editor, setting a breakpoint and invoking the report. Debuger pops up, after pogram termination the debuger window keeps open in the background while i'm back in the editor.

/i closes both the editor and the debuger, if these are the only sessions i'm asked if i really want to log off.

/hx closes the debuger window only

Re: Terminating debugger session window

GauthamV — Tue, 02 Feb 2010 11:00:29 GMT

If i do the same these are my results.

/i closes both the editor and the debugger, and takes both sessions to SAP easy access screen.

/hx doesn't have any effect at all,still remains in debugging mode.

Re: Terminating debugger session window

Former Member — Tue, 28 Jan 2020 14:10:31 GMT

Hi Rainer,

to close the debug sessione when the transaction ending, you have to start any debug and than you have to go to "Settings" -> "Changing Debbugger Profile/Settings" and set flag "Close Debugger after 'Continue'(F8) and Roll Area end"

Regards

Mara

Re: Terminating debugger session window

gayathri_jayajeevan2 — Fri, 07 Feb 2020 11:56:07 GMT

/hx is used to cancel the debugger session explicitly. And the other option is as Maria mentioned, setting "Close Debugger After Continue‘F8’ And Roll Area End".