topic Re: selection Screen in Application Development and Automation Discussions

selection Screen

Former Member — Fri, 20 Nov 2009 06:56:48 GMT

Hi ,

I have two block on sclections screen. In one block , one check box & on second block, there are 3 check box.

When I click on check box of 1st block, all the checkbox of 2nd block should be unchecked & use should not be check these, but these sud be on screen.

How can i do that? with the use of loop at screen if yes then please tell me what screen field i will be change?

Thanks in advance..

Re: selection Screen

Former Member — Fri, 20 Nov 2009 07:03:28 GMT

Hi,

Code in AT SELECTION SCREEN OUTPUT event.

Use screen-input = 0 for greying the checkbox.

You can find loads of examples on the SDN

Re: selection Screen

kesavadas_thekkillath — Fri, 20 Nov 2009 07:07:22 GMT


selection-screen BEGIN OF block b1.
parameters:p_ch1 as checkbox user-command UC default 'X'.
selection-screen end OF block b1.
selection-screen BEGIN OF block b2.
parameters:p_ch2 as checkbox.
parameters:p_ch3 as checkbox.
selection-screen end OF block b2.

at selection-screen output.

loop at screen.
if screen-name = 'P_CH2' or screen-name = 'P_CH3'.
  screen-input = 0.
  MODIFY SCREEN.
endif.
endloop.
if p_ch1 = ' '.
p_ch2 = p_ch3 = 'X'.
else.
p_ch2 = p_ch3 = ' '.
endif.

Re: selection Screen

Former Member — Fri, 20 Nov 2009 07:10:33 GMT

Thanks all of you . I also doing same but in at selection on field..Thanks again for your reply..

Re: selection Screen

Former Member — Fri, 20 Nov 2009 07:13:10 GMT

You can do this on the event : AT SELECTION SCREEN OUTPUT.

loop at screen.

IF R1 = 'X'.

if screen-field = 'R2'.

SCREEN-INPUT = ' '.

R2 = ' '.

ENDIF.

if screen-field = 'R3'.

SCREEN-INPUT = ' '.

R3 = ' '.

ENDIF.

if screen-field = 'R4'.

SCREEN-INPUT = ' '.

R4 = ' '.

ENDIF.

MODIFY SCREEN.

ENDIF.

endloop.