topic validating non key fields in table maintenance generator in Application Development and Automation Discussions

validating non key fields in table maintenance generator

Former Member — Fri, 13 Nov 2009 06:10:36 GMT

Hi,

I ma using events for table maintenance generator event 05 ,there i want to validate non key fields ......i am throwing error message ....all the non key fields are getting in display mode ...i need them to enable to enter values ....

please suggest

Thanks,

Shailaja Ainala.

Re: validating non key fields in table maintenance generator

Former Member — Fri, 13 Nov 2009 06:17:28 GMT

Hi,

Write a code between chain and endchain. as follows

chain

for validation of field ,select the data from check table of particular fields based on entered value.

and check the sy-subrc value , if it give 4 then raise a error message.

endchain

Re: validating non key fields in table maintenance generator

Former Member — Fri, 13 Nov 2009 06:18:49 GMT

through event i want .......i have checked the fields are in chain and endchain only ....

Thanks,

Shailaja Ainala.

Re: validating non key fields in table maintenance generator

Former Member — Fri, 13 Nov 2009 06:41:37 GMT

Hi Shailaja,

Its property of error message, which makes it as non-editable.

You can display either status or info message after validation check.

And finally before saving (before save event) display error message, so that it invalid entries doesnt get saved.

Thanks,

Nisha Vengal.