topic Re: after upgrade problem with varient in Application Development and Automation Discussions

after upgrade problem with varient

Former Member — Thu, 29 Oct 2009 10:57:57 GMT

hi .

after upgrade from 4.6c to Ecc 6,some of my z reports not showing Varient..which was present in 4.6c. how can i reload the vairent?? any idea?

Re: after upgrade problem with varient

Former Member — Thu, 29 Oct 2009 11:10:35 GMT

Hi,

Check below threads:

Hope this helps

Regards

Shiva

Re: after upgrade problem with varient

Former Member — Thu, 29 Oct 2009 11:16:21 GMT

hai,

if you update your report from one version to another the varient which was created in older version will be deleted, so you have to create it again.

Re: after upgrade problem with varient

Former Member — Thu, 29 Oct 2009 14:01:58 GMT

thanks for replyies

i try to run report

RASUVAR1

to save my varient in source system so i will be use it after upgrade to restore the varient..but this report not exist in 4.6c .any alternate to save and restore all varients

Re: after upgrade problem with varient

Former Member — Thu, 29 Oct 2009 15:11:55 GMT

Run the program RSVARDOC_610. Enter u201CZ*u201D and keep the defaults for the remaining selection screen parameters.

Mithun.

Re: after upgrade problem with varient

Former Member — Wed, 02 Dec 2009 13:37:24 GMT

still pending