topic Re: lsmw using ALE/IDOC Method in Application Development and Automation Discussions

lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 05:56:46 GMT

Hi Team,

I am trying for lsmw using ALE/IDOC Method.

I have defined the segment type, message type, defined a basic type and defined a partner profile of the receiver system.

When i try to execute the Start Idoc Generation step in generating LSMW creation steps. I am getting below error "No partner exists with the nae ", type".

Please help me in resolving the warining.

No partner exists with the name '', type ''

Regards

Sunil

Edited by: sunil kumar on Jul 30, 2009 11:26 AM

Re: lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 06:03:57 GMT

Hi,

Did you created customer model view ? using BD64 create the model view and distribute the model view and genrate the partner profiles.

hope it will work and let me know do you want any help .

~linganna

Re: lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 06:25:03 GMT

Hi,

I created a distribution model and assigned message type. When i try to generate partner profiles and checked the check run box. Execute it and am getting a message "No messages have been defined for the selection conditions in the model" could you let me know where have i gone and wrong and also the solution.

Regards

Sunil

Re: lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 07:36:22 GMT

Hi,

Before genarating partnerprofiles you need to compleate distribute model view .

and check alll the ALE configarations.

~linganna

Re: lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 08:01:17 GMT

Hi,

for LSMW , you have to create partner profile type as 'US'.

once the partner profile created in we20,

goto tcode lsmw , in menu select "Settings -> Inbound Idoc Processing"

maintain FilePort, partner type and Partner number and then press Activiate Idoc Inbound pricessing.

Then you will not get this error message.

Regards,

Bhavana

Re: lsmw using ALE/IDOC Method

Former Member — Thu, 30 Jul 2009 09:21:01 GMT

HI Bhavana,

Thanks for your answer, but eventhough after defining the partner type as US and adding settings under Inbound Idoc processing. It is still displaying the same information message.

Regards

Sunil