topic at user-command with input on in Application Development and Automation Discussions

at user-command with input on

Former Member — Thu, 16 Jul 2009 06:37:20 GMT

Hi,

In the below code i am using an option input on ,where the user has to give the inputs manually.

After giving the input,if i give save the values which are fetched from itab are saved in ztable.

wa_new-idrum1 which is given by user is not saving in ztable.

Suggest some ideas.

Regards,

Bathri.

  LOOP AT IT_NEW INTO WA_NEW.
    SKIP.
    WRITE : / SY-TABIX,
              WA_NEW-MATNR,
              WA_NEW-MENGE LEFT-JUSTIFIED,
              40 WA_NEW-IDRUM1 LEFT-JUSTIFIED INPUT ON.
  ENDLOOP.


  SET PF-STATUS 'ZWORK'.

AT USER-COMMAND.
  CASE SY-UCOMM.
    WHEN 'SAVE'.
      LOOP AT IT_NEW INTO WA_NEW.
        MOVE : WA_NEW-MATNR TO ZWORK-MATNR,
               WA_NEW-MENGE TO ZWORK-MENGE,
               WA_NEW-IDRUM1 TO ZWORK-IDRUM1.
        MODIFY ZWORK.
      ENDLOOP.
  ENDCASE.

Re: at user-command with input on

Former Member — Thu, 16 Jul 2009 07:15:35 GMT

Cause the internal table is not modified at list when user enter the values no update of ztable done. To correct try something like following

DATA: BEGIN OF IT_NEW OCCURS 100,
        MATNR  TYPE MATNR,
        MENGE  TYPE MENGE_D,
        IDRUM1 TYPE CHAR20,
       END OF IT_NEW.
DATA WA_NEW LIKE LINE OF IT_NEW.
DATA MENGE TYPE CHAR20.

START-OF-SELECTION.
  SELECT  * FROM MSEG UP TO 60 ROWS
    APPENDING CORRESPONDING FIELDS OF TABLE IT_NEW.
  LOOP AT IT_NEW INTO WA_NEW.
    SKIP.
    WRITE : / SY-TABIX,
              WA_NEW-MATNR,
              WA_NEW-MENGE LEFT-JUSTIFIED,
              40 WA_NEW-IDRUM1 LEFT-JUSTIFIED INPUT ON.
  ENDLOOP.
  SET PF-STATUS 'ZWORK'.

AT USER-COMMAND.
  CASE SY-UCOMM.
    WHEN 'SAVE'.
      DO.
        CLEAR: ZWORK,MENGE.
        READ LINE SY-INDEX
        FIELD VALUE WA_NEW-MATNR  INTO ZWORK-MATNR
                    WA_NEW-MENGE  INTO MENGE
                    WA_NEW-IDRUM1 INTO ZWORK-IDRUM1.
        IF SY-SUBRC NE '0'.
          EXIT.
        ENDIF.
        DO.
          REPLACE '.' WITH '' INTO MENGE.
          IF SY-SUBRC NE '0'.
            EXIT.
          ENDIF.
        ENDDO.
        REPLACE ',' WITH '.' INTO MENGE.
        CONDENSE MENGE NO-GAPS.
        ZWORK-MENGE = MENGE.
        IF ZWORK-MATNR IS NOT INITIAL.
          MODIFY ZWORK.
        ENDIF.
      ENDDO.
  ENDCASE.

Re: at user-command with input on

Former Member — Thu, 16 Jul 2009 09:28:16 GMT

Hi,

Thank you very much.Its working fine.

Regards,

Bathri.