topic Re: customized report, executing using a variant in Application Development and Automation Discussions

customized report, executing using a variant

Former Member — Wed, 15 Jul 2009 12:31:39 GMT

hello,

we do have a customized z report that shows open orders.

One result column shows stock on hand.

However, I am facing a strange problem: when I execute the report by entering the selection data by myself, the data in the on hand column are shown correct.

But if I execute the report with a saved variant that has the same entries I have made manually, the data in the on hand column are not shown correctly, all values are set to zero.

Do you have any idea what's the problem here?

Thanks

Anne

Re: customized report, executing using a variant

Former Member — Wed, 15 Jul 2009 12:37:28 GMT

Hi Anne

the best way to find this kind of error is

put the break point in your program where you are selecting the data and see through debugging both the scenarios.

See during the select statement in both the scenarios you have the same values.

Regards

Sajid

Edited by: shaik sajid on Jul 15, 2009 2:37 PM

Re: customized report, executing using a variant

Former Member — Wed, 15 Jul 2009 12:37:37 GMT

The problem is with the variant you have saved.

Run your report without variant and then save into same variant.

Again run the report using variant and check, is there any difference now?

Regds,

Anil

Re: customized report, executing using a variant

former_member212005 — Wed, 15 Jul 2009 12:50:36 GMT

Anne...are you using TABS?

The problem is in the variant that you have saved...

Debug and check, which value was not passed....

Re: customized report, executing using a variant

Former Member — Wed, 15 Jul 2009 14:13:14 GMT

Hi,

I have created a new variant and for some reasons it was working then.

Maybe there was an issue with the existing variant.

Thanks all of you