topic Re: Regarding Debugging in Selection screen in Application Development and Automation Discussions

Regarding Debugging in Selection screen

Former Member — Sat, 27 Jun 2009 12:08:46 GMT

Hi All,

I have a program when it will call a screen screen it will go to the debugging screen , could you plz tell me the ans.

Regards,

Nihar

Re: Regarding Debugging in Selection screen

Former Member — Sat, 27 Jun 2009 12:19:28 GMT

Hi,

Code the BREAK-POINT statement either in the INITILIZATION event or in the AT SELECTION-SCREEN OUTPUT event.

Regards,

Ankur Parab

Re: Regarding Debugging in Selection screen

Former Member — Sat, 27 Jun 2009 12:31:30 GMT

Hi Ankur Parab ,

Thanks for replay , actually the questiion is: they have a report program and inside the report it will call a selection screen of another program , when it call that selection screen it will go debugging mode and also they want to do debugging for message. plz help me

Re: Regarding Debugging in Selection screen

Former Member — Sat, 27 Jun 2009 12:37:36 GMT

Hi,

Sorry I fail to understand your scenario.

If you want to go to debugging screen of the selection-screen then in that program code the break-point statement in the AT SELECTION-SCREEN OUTPUT event.

When you call the screen the debugger will be show before the screen is output.

Regarding also they want to do debugging for message I do not understand what do you mean by that.

regards,

Ankur Parab

Re: Regarding Debugging in Selection screen

venkat_o — Sun, 28 Jun 2009 03:51:01 GMT

Hi Nihar, steps to go in debug mode in called program. <li>Put break-point on SUBMIT statement. Submit statement calls another program. <li>Before run calling program after entering selection-screen, give

/H

in command field and press

ENTER

. <li> Now Check , Break-point At menu in the menu bar, select statement and now give MESSAGE statement.It stops when MESSAGE is reached. I hope that it helps you. Thanks Venkat.O