topic Re: Reg: Outbound Error Populating in Custom Program in Application Development and Automation Discussions

Reg: Outbound Error Populating in Custom Program

Former Member — Mon, 15 Jun 2009 15:35:33 GMT

Hi All

My problem is on OUTBOND SIDE.....

i am creating custom outbound idoc with Z* Program...

During creating of idoc i use to pick data from different table...

i would like to falied the idoc in error with error message if data is initial in a field in segment...

Segment : ztest_h

field : soldto

field: add

field :....

field:.....

segment : ztest_i

field : po_num

field: qty

field :....

field:.....

.....

for example...

if no data in soldto & po_num ....fields... i would like to add a status record in outbound with status

07 with error message

Missing data in soldto field in segment... ztest_h

Missing data in po_num field in segment...ztest_i

Question is...

how to pass the status records while creating in O/B Idoc.....

Thanks

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Mon, 15 Jun 2009 22:11:33 GMT

we need to push data into EDIDS strucutre with appropriate meesage type ;E; and message number..IDOC will be displayed in error..

regards

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Wed, 17 Jun 2009 15:11:28 GMT

how can we puch the data in EDIDS....

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Wed, 17 Jun 2009 15:16:04 GMT

hi ,

it is not possible the status messages are predefined ..

for syntax error status-26 for success 53 and for all types error messages are created by SAP.

and you can create own messages type after 71-99..

by going to t-code wedi and check the messages configuration tab and created own messages..

Prabhudas

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Wed, 17 Jun 2009 19:14:42 GMT

i got you point ... i am aware of that...

My question IS......how can we pass status records error Message during outbond interface..

say for example

i created a custome error message say status 81 ..which is error...

how can i pass status records... while creating outbound idoc...

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Thu, 18 Jun 2009 14:14:30 GMT

I resolved my issue ...

answer to my question is ... it is possible.... i written code to populate error idoc status in outbound side..if any data missing is segments fields...

Re: Reg: Outbound Error Populating in Custom Program

Former Member — Wed, 12 Aug 2009 14:05:50 GMT

Hi Ramesh,

Would you mind sharing your solution with us, as we have similar requirement? Further question is this: can we assume that the IDOC will not be sent to PI in this case, giving time to amend the missing data before sending out?

thx!