topic Re: validation for incoming data from the structure in Application Development and Automation Discussions

validation for incoming data from the structure

Former Member — Tue, 02 Jun 2009 07:28:13 GMT

Hi.

i have to do the validation for the incoming data from the structure based on a key field.

say from example,if no material found for that key field,give the error.

in this case,what could be the select and sy-subrc statement.

thanks in adv.

Former Member — Tue, 02 Jun 2009 07:32:10 GMT

Hi,

At run time, let's say MARA structure MATNR field got populated with the material number and you want to validate it.

Then write a select command like,

SELECT SINGLE MATNR

FROM MARA

INTO V_MATNR

WHERE MATNR = MARA-MATNR.

IF SY-SUBRC not equal to 0.

MESSAGE E000 WITH 'No suitable material found for the selection'.

ENDIF.

But do remember that, validation for the particular field will be done on it's check table only if it is available.

Regards,

Santhosh

Former Member — Tue, 02 Jun 2009 07:35:01 GMT

write select single command and then

if sy-subrc = 0.

then pass e000 message (error messgae)

Former Member — Tue, 02 Jun 2009 07:46:58 GMT

Hi,

If you want stop the execution then go for the error i.e E.

Or if you want to proceed with the execution without stopping then go for the warning message.

If sy-subrc not equal to 0.

Endif.

Aswarth

Edited by: Aswarthanarayana Mylavaram on Jun 2, 2009 9:47 AM

Edited by: Aswarthanarayana Mylavaram on Jun 2, 2009 9:48 AM