topic Re: RFC Connection not working between ECC5 to ECC6 system in Application Development and Automation Discussions

RFC Connection not working between ECC5 to ECC6 system

Former Member — Fri, 08 May 2009 05:32:09 GMT

Hi all,

I have created RFC connection ( connection type is ABAP) in SM59 to connect my ECC 5 to ECC6 system for transfer data using ALE, i have given all the details in RCF connection and connection test is also working fine from ECC5 to ECC6 but when i distribute the model in BD64 it is showing me error "Model can not be distributed communication error, user name or password in not correct*" then i checked connection in SM59 and test the connection for authorization test here i am getting the same error but with same user id and password i can login into the ECC6 system.

here ECC 5 is my sending system and ECC 6 is receiving system, and connection is not working from ECC5 to ECC6 where as from ECC6 to ECC5 connevtion is fine

Please help in this Regard.

Thanks & Regards

Madhu

Re: RFC Connection not working between ECC5 to ECC6 system

abdul_hakim — Fri, 08 May 2009 06:02:44 GMT

The user might not have been registered as RFC User. Check with the BASIS regarding this issue.

Regards,

Hakim

Re: RFC Connection not working between ECC5 to ECC6 system

jaideepsharma — Fri, 08 May 2009 15:53:24 GMT

Hi,

Try to change user type to SYSTEM or Communication if it Dialog or for test purpose create a user of type System user and test whether model gets distributed.

KR Jaideep,

Re: RFC Connection not working between ECC5 to ECC6 system

Former Member — Fri, 08 May 2009 19:58:44 GMT

Hi,

In ECC 5 , can the user able to LOGIN ?(dialog user)

Secondly , Check the Target Host, gateway service ( ECC 5).

Regards,

Re: RFC Connection not working between ECC5 to ECC6 system

Former Member — Sun, 10 May 2009 19:33:52 GMT

Sounds like a problem of downward incompatibility of passwords caused by lower- and UPPER-case characters.

This means that the higher release is expecting a case-sensitive password, but the lower one (and components in between) are converting the password to UPPER-CASE.

If the user is only used in this connection... set a password with all characters in UPPER-CASE in the ECC 6.0 system and test again.

Alternately take a look at the RZ11 profile login/password_downwards_compatibility. You can instruct the higher system to evaluate a password sent by a lower release system, if the new hashing mechanism fails. So it uses both until all connecting systems are compatible.

I prefer a mimic of the old mechanism (entering the password in UPPER-CASE) than using downward compatibility (both mechanisms).

Cheers,

Julius

Re: RFC Connection not working between ECC5 to ECC6 system

Former Member — Mon, 11 May 2009 05:01:55 GMT

Hi,

Provide the right password and check with authorization test. It should work. Alternatively, check if the user exists in SU01D transaction and is extended to the system ECC6.

~ Bineah.

Re: RFC Connection not working between ECC5 to ECC6 system

Former Member — Wed, 17 Jun 2009 08:20:54 GMT

Answered..