topic Re: ikon selection in Application Development and Automation Discussions

ikon selection

Former Member — Fri, 22 May 2009 09:32:34 GMT

Hi all.......

I had displayed 5 ikons ( as Hot-Spot ) in a report out-put.

by clicking on each ikon different code should be executed ( written in perform statements ) should be called....

pseudo code will be like this......

WHEN 'icon_list'.

perform addition.

WHEN 'ICON_OKAY'.

PERFORM substraction.

Re: ikon selection

Former Member — Fri, 22 May 2009 09:45:28 GMT

Hi,

Do it this way..

INCLUDE <icon>.
WRITE /: icon_green_light AS ICON HOTSPOT,
         icon_red_light AS ICON HOTSPOT.

AT LINE-SELECTION.
  CASE sy-lisel.
    WHEN '08'.
      WRITE:/ 'abcd'.
    WHEN '0A'.
      WRITE:/ 'xyz'.
  ENDCASE.

write /: 'Addition' as hotspot,
           'Subtraction' as hotspot.

at line-selection.
 case sy-lisel.
  when 'Addition'.
       perform addition.
  when 'Subtraction'.
       perform 'Subtraction'.
 endcase.

you can get the value of the icon when you debug it.

Example: " icon_green_light = 08 , icon_red_light = 0A

Thanks&Regards

Sarves

Re: ikon selection

Former Member — Fri, 22 May 2009 09:46:10 GMT

Hi Kiran,

If u have displayed the icons using pf-status then please refer the below sample,

set pf-status 'GUI_CODE'
     CASE SY-UCOMM.
    WHEN 'ICON_LIST'.
    perform addition.

   WHEN 'ICON_OKAY'.
   PERFORM substraction.
ENDCASE.

Thanks

Karthik.

Re: ikon selection

Former Member — Fri, 22 May 2009 09:55:24 GMT

Hi ,

using SET PF-STATUS 'TEST1' create a status and define the fcodes .

data: ok_code TYPE sy-ucomm.

then in program use

CASE ok_code.

WHEN 'ADD

PERFORM ADDITION

WHEN 'SUB

PERFORM SUBSTRACTION.

ENDCASE.

regards

gowri