topic Re: Problem in enhancing RFC in Application Development and Automation Discussions

Problem in enhancing RFC

Former Member — Tue, 19 May 2009 04:03:17 GMT

Hi All,

I am enhancing RFC HRMSS_CAT_WD_APPROVAL. But the problem is that I cannot see the enhanced code in RFC itself. Also, while debugging, the control does not go to the enhanced code.

If you have any pointers regarding this, please let me know.

Regards,

Ridhima

Re: Problem in enhancing RFC

Former Member — Tue, 19 May 2009 04:24:23 GMT

hi,

I my view make a copy and make the req changes.

Atul

Re: Problem in enhancing RFC

Former Member — Tue, 19 May 2009 04:26:18 GMT

Hi.

Is your enhancement implementation active? Check.

Also look at code of function module and how lv_debug variable is used there.

May be depending on value that it contain, system supresses debugger.

Re: Problem in enhancing RFC

Former Member — Tue, 19 May 2009 04:28:47 GMT

I mean this code

*********************************************************
* Debugging                                              *
*********************************************************
  SELECT SINGLE parva FROM usr05 INTO lv_parva
     WHERE bname = sy-uname AND parid = 'CATS_FACE_DEBUG'.
  IF lv_parva CA 'X'.
    lv_debug = 'X'.
    WHILE lv_debug CA 'X'.
    ENDWHILE.
    lv_debug ='X'.
  ENDIF.

Re: Problem in enhancing RFC

Former Member — Tue, 19 May 2009 04:30:21 GMT

Yes the enhancement implementation is active. It is going in debug mode in RFC but not at enhanced code